Answer: Yes! In some cases, a little air in the returns at the pool is okay. If you have an ozone generator, this will add air into the pool, as most of the injection points are at the pool equipment. You should only see air in a few locations, though.
Air will follow the path of least resistance, so if your pool return manifold has multiple pipes, you could see air bubbles from each of those return spots in the pool. Typically, pool returns are connected together, so if you have four pool return eyeballs, you would see the air bubbles coming from the one nearest the equipment. Spa common lines would be another example.
Having air coming from all the returns and all around the pool could signify a bigger issue. Pool systems are considered closed systems, and air will enter on the suction side only. This includes everything from the pump lid, front drain plug, and plumbing entering the pump from the suction manifold, such as skimmers and main drain lines.
Everything from the pump discharge pipe and rear plug through the other components, such as the filter and heater, is pressurized, so there would usually be a drip or spray leak. This narrows down where you need to look. Don’t forget the water level in the pool either. Most pools are equipped with an overflow grate, and the water level in the pool should be just below this.
The number one culprit would be a dirty pump lid O-ring. It’s amazing how a tiny seed pod could cause so much headache. Shutting the pumps off and leaning down to listen for an air draw sound would be the first thing to do. You can also put your ear up against the valves.
Pulling the pump lid off to check the O-ring and inspecting it for debris and cracks would be the next thing you should do. Also keep in mind that there are weir doors in skimmers, also known as swing flaps. Debris can hang them up and cause the skimmer to empty out, which would allow air to make it into the pump pot.
Last, check filter pressures. Filter pressure should be less than 30 psi. Sometimes different setups can allow filter pressure to be at 30 psi, but it should not normally be over 30. Dirty filters can prevent the pump from fully priming, which could add air into the system.
Confirming that your pump lid O-rings are plump, supple, and free of debris can eliminate a lot of air and flow issues. Ensuring the pool’s filter is cleaned regularly and baskets are cleared is also beneficial, and maintaining the proper water level is paramount.
Do you have questions you’d like help with from Joel? Give us a call at (281) 351-2577 and ask for him by name, or send us an email at info@poolmaninc.com. Let’s see what we can do to help make pool ownership a fun experience instead of a high-maintenance worry!