Joel Talks – Pool Service Q&A: Salt Water Pool Maintenance

Our Service Manager, Joel Fitzgerald, has been with The Pool Man for 18 years, most of which he spent as our “boots on the ground” filling the role of Senior Service Technician. With over 22 years of industry experience, he’s seen a lot and been asked a lot, so what better source to answer some FAQs online to help folks out? This week, we’re going to talk about saltwater pools and what to do when your salt cell is in need of service.

Customer Question: “Why is my salt cell saying I need to add salt?”

#1 Answer: Most salt cells are calibrated in water temperatures above 70 degrees, so it is not uncommon to receive this warning when water temperatures drop into the 60s. The general rule of thumb is that for every degree below 75, the correction is roughly 150 ppm. So if your water is at 65 degrees, the salt reading could be as low as 1,500 ppm if you are usually at 3,000 ppm.

Do not add salt right away! This is where customers get into trouble. You need to know the true salt reading by either self-testing with a wand or having it professionally tested. Adding salt to a pool that already has enough salt can create other issues that are not fun to deal with.

#2 Answer: The ideal range for salt in a pool is 2,800–3,400 ppm. It is also typical to have a variance of around 500 ppm. Most issues associated with salt levels being either too high or too low are well outside of this range.

Systems that display the salt level make this issue easier to see. For example, if your salt system is telling you that your salt level is too low and displaying 2,000 ppm, but you have it tested and the test shows the level at 2,500 ppm, this is not an issue. Your salt level needs to be raised. If the test shows your salt is 3,000 ppm and the displayed amount is 1,500 ppm, this is most likely due to a dirty or faulty salt cell.

Tips/Tricks

Salt cells should be inspected every three months for corrosion buildup. Some will have a preset timer for this with an “Inspect Cell” light. The general rule of thumb for salt cells and salt level issues is to first clean the cell using a solution of one part acid to three parts water.

This is preferably done with a salt cell cleaning kit rather than dunking the cell in a bucket. If the issue persists, you can either take the cell to a testing station like Leslie’s or Pinch A Penny, or call a service company to come out and check it.

Takeaways

The general life expectancy of salt cells is 3–4 years. They can last well beyond that range, but this depends on how hard they have been asked to work. Salt cells set at 75% output will not last as long as cells enjoying the sweet life at 45% output.

Cyanuric acid levels, also known as CYA, are very important with salt cells and need to be maintained because the chlorine produced from salt cells is not stabilized and will not last long when the sun is out.

Controlling your pH is also just as important. The process of converting salt, or NaCl, to chlorine, HClO and NaClO, creates high pH when splitting the salt compound. Adding acid, or HCl, to lower your pH will actually reform the salt compound and, if done regularly, can reduce the amount of salt you need to add to your pool.

Maintaining water levels and attending to siphon issues is also paramount. The two biggest destroyers of salt levels are leaks at the equipment or spas draining/siphoning to the pool when the equipment is off. If you have an auto-fill maintaining your pool level, you may not even notice this until you start testing your chemistry.

A sure tell-tale sign is your CYA or calcium levels decreasing, as these do not evaporate or dissipate. You only lose CYA and calcium through dilution or splash-out.